Coal mine ventilation air contains methane at a concentration of 0.1–1% at very high flow rates. Efficient extraction and utilization of this methane is achieved through adsorptive concentration on thermally expanded graphite (TEGA) with vacuum regeneration.
Operating Principle
The process is organized according to a vacuum pressure swing adsorption (VPSA) scheme.
Adsorption
The ventilation air stream passes through a bed of TEGA.
Methane is selectively retained by the sorbent, while the bulk of the nitrogen and oxygen passes through.
This produces primary concentration of methane on the TEGA surface.
Flow Switching
The system is built as a multi-chamber design. While one chamber operates in adsorption mode, another is undergoing regeneration. This ensures continuous operation.
Vacuum Regeneration
Once TEGA is saturated with methane, the chamber switches to vacuum desorption.
Under deep vacuum, methane is released from the sorbent surface and withdrawn as an already-enriched gas.
Vacuum regeneration allows methane to be efficiently recovered at relatively low energy cost and restores the sorbent to its working state.
Producing the Enriched Stream
The outlet after regeneration forms a gas stream with a substantially higher methane concentration compared to the original ventilation air.
Use of the Enriched Methane
The enriched methane can be directed along two main paths:
To a furnace or heat generator
The increased concentration allows the gas to be burned stably and the heat usefully recovered (heating water, air, or other process needs).
For further processing
The enriched stream is fed into a vacuum module for additional concentration or preparation of the gas for use as fuel.
Technical Implementation
The adsorption chambers are designed with minimal hydraulic resistance to avoid creating excessive pressure drop in the mine’s ventilation network.
Dust collection is installed ahead of the TEGA to prevent coal dust from reducing sorbent efficiency.
Process control is fully automatic: switching between adsorption and regeneration modes, maintaining vacuum, and monitoring outlet methane concentration.
The system is built modularly and can be scaled up depending on the ventilation air flow rate.
Result
The ventilation air passes through the unit, methane is extracted and concentrated on TEGA, and after vacuum regeneration an enriched methane-containing stream is obtained, which is either burned to generate heat or sent for further processing in the vacuum module.
This scheme allows methane to be continuously extracted from large volumes of ventilation air, turning it from a harmful emission into a useful energy resource.
Also published on: LinkedIn — Michael Vischmidt · Facebook — ARBOK Institute
